FAA / Advisory circular

AC 27-1B

Certification of Normal Category Rotorcraft — Changes 1–9

Normal category rotorcraft guidance with Changes 1–9 incorporated. Search the complete AC or start with the system safety, flight controls and instrument-flight guidance.

Start with the scope.

This source includes guidance for different amendments of Part 27. Match the guidance to the aircraft’s agreed certification basis: the 27.1309 entries for Amendments 27-21, 27-46 and 27-51 are separate. The base AC was issued on 30 September 1999; Change 9 is dated 23 June 2023. The FAA catalogue’s 30 September 2008 date is not the date of the latest change.

The source, within reach.

Search within this AC, jump to a source page, or download the complete saved publication.

Download saved FAA PDF ↓

Read the source

The document, within reach.

FAA source document

PDF page 1014

PDF page 1014 of 1196

Enlarge original ↗

Original FAA page, including its printed amendment and change markings. Extracted words support search; text reflow has not been reviewed.

Original FAA AC 27-1B, PDF page 1014
AC 27-1B · 1014Open saved PDF here ↗
Extracted text for finding words

This extraction supports search. Read the original page for complete notation and layout.

AC 27-1B, Chg 7                                                                       2/4/2016


Note:  For additional definitions related to safety assessments, refer to section 27.1309 and MG 21
       (FHA) of this AC.

     c. Display Description.

         (1) General.

                  (i) EDS displays and installations range from individual representations of ADI and HSI to
fully integrated display suites combining primary flight and navigation information on a single display, a
PFD and powerplant/system information on another display, or EICAS display. The flexibility allowed by
the technology provides display designers wide latitude in how and where to display information to the
pilot. Other displays or MFD of supplementary information may also be included in the installation.

                    (ii) The display layout and format of information may range from digitally rendered
representations of conventional “round-dial” electromechanical gauges and instruments to tape displays
to hybrid “round-dial” representations. Regardless of the format, the information displayed must be easily
accessible and understandable by the pilot.

                     (iii) Retrofitting EDSs into existing “round-dial” or analog cockpits can create challenges due
to interfaces with previously installed avionics and autopilot systems. There should be an evaluation of
these installations to ensure the pilot-system interface does not increase or significantly change the focus
of pilot workload in order to manage and operate the system.

                (iv) EDSs have the capability to combine the display of multiple flight, navigation, and
powerplant parameters on to a single display, resulting in the loss of independence provided by individual
gauges or instruments. As a result, considerations regarding loss of required information must account
for a possible single failure leading to the loss of all flight, navigation, or powerplant information on a
display.

         (2) Basic flight and navigation information.

                  (i) 14 CFR 27.1303 and Appendix B to part 27 define required flight and navigation
instruments.

                    (ii) Flight Instruments: There are different instrument requirements for VFR and IFR rotorcraft
(see Appendix B to part 27, VIII). Consult operational regulations (e.g., parts 91 and 135) for any
additional flight instrument requirements. Flight instruments that are not required by § 27.1303 but are
installed to satisfy either an operational requirement or to enhance safe operation of the rotorcraft should
be located as close as possible to the pilots’ center line of vision. For example, radar altimeters should
be installed where pilots can easily incorporate the gauge into their airspeed and altitude scan. Placing a
radar altimeter or other flight instruments at the maximum extent of the pilots’ secondary field of view
makes the instrument difficult to incorporate into an efficient scan and increases pilots’ workload.

                     (iii) Navigation information.

                (A) The display of navigation information can be either on the PFD or on an EHSI.
Supplemental navigation information, such as moving maps, can be displayed on MFDs. However, the
EHSI or PFD should provide the pilot with course and heading adherence, coupled with the information
required for the pilot to attain and maintain awareness of the rotorcraft’s position relative to navigation
waypoints and action points.

                (B) Navigation equipment requirements are also given in operational rules (For example,
§§ 91.205 and 135.143). Display requirements for navigation information depend on which navigation
system is installed in the rotorcraft. Electronic display installations may affect the instruments and
equipment required for flights under part 91 and part 135. These instruments and equipment include



Page MG 19 -12

Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.

Aerospace Consulting / Engineering perspective

Start with the certification basis and the function.

Identify the applicable amendment before selecting the safety guidance. Connect intended functions and operating conditions to failure conditions, architecture decisions, common-cause considerations, verification and limitations. For flight controls and IFR work, carry the relevant 27.672, 27.1329 and Appendix B assumptions into the system safety and compliance evidence.

Explore the rotorcraft safety and certification approach →
Source edition and reading coverage

1196 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.

Source SHA-256: 2dfac16a3644dc18997069cca78746c10726e4b70d3aba996fc87843ffe68a2b

This is a dated source copy. Automatic source acquisition is not yet scheduled.

Original FAA PDF ↗

Working through a certification question?

Bring the aircraft, the basis and the issue your team needs to resolve.

Discuss your programme →