Appendix A gives an acceptable means for certain powered-lift under §21.17(b). These criteria are not universally applicable CFR requirements; establish the basis for the particular aircraft.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
07/18/2025 AC 21.17-4
Appendix A
PL.3539 Endurance test.
Endurance tests on the propeller system must be made on a representative engine in accordance
with paragraph (a) or (b) of this section, as applicable, without evidence of failure or
malfunction.
(a) Fixed-pitch and ground adjustable-pitch propellers must be subjected to one of the following
tests:
(1) A 50-hour flight test in level flight or in climb. The propeller must be operated at takeoff
power and rated rotational speed during at least five hours of this flight test, and at not less than
90 percent of the rated rotational speed for the remainder of the 50 hours.
(2) A 50-hour ground test at takeoff power and rated rotational speed.
(b) Variable-pitch propellers and all engine-driven lift devices must be subjected to one of the
following tests:
(1) A 110-hour endurance test that must include the following conditions:
(i) Five hours at takeoff power and rotational speed and thirty 10-minute cycles composed of:
(A) Acceleration from idle,
(B) Five minutes at takeoff power and rotational speed,
(C) Deceleration, and
(D) Five minutes at idle.
(ii) Fifty hours at maximum continuous power and rotational speed,
(iii) Fifty hours, consisting of ten 5-hour cycles composed of:
(A) Five accelerations and decelerations between idle and takeoff power and rotational speed,
(B) Four and one half hours at approximately even incremental conditions from idle up to, but
not including, maximum continuous power and rotational speed, and
(C) Thirty minutes at idle.
(2) The operation of the propeller throughout the engine endurance tests prescribed in these
airworthiness criteria.
(c) For propellers having higher ratings or rotational speeds than takeoff power and rated
rotational speed, those ratings and speeds must be used in the tests required by paragraph (a) or
(b) of this section.
(d) If a propeller can be tilted from vertical to horizontal operation and vice versa, the transitions
must be performed as part of the tests required by paragraph (a) or (b) of this section.
PL.3540 Functional test.
The variable-pitch propeller system must be subjected to the applicable functional tests of this
section. The same propeller system used in the endurance test of PL.3539 must be used in the
functional tests and must be driven by a representative engine on a test stand or on the aircraft.
The propeller must complete these tests without evidence of failure or malfunction. This test may
be combined with the endurance test for accumulation of cycles.
A-48
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Begin with the aircraft and the agreed basis.
Connect the operating concept, aircraft-level failure effects, system architecture and assurance planning. Keep FAA powered-lift criteria and EASA SC-VTOL provisions distinct when developing the safety and certification approach.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.