Appendix A gives an acceptable means for certain powered-lift under §21.17(b). These criteria are not universally applicable CFR requirements; establish the basis for the particular aircraft.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
07/18/2025 AC 21.17-4
Appendix A
Appendix A. Airworthiness Criteria for Powered-Lift
AIRCRAFT LEVEL REQUIREMENTS
PL.1457 Cockpit voice recorders.
(a) Each cockpit voice recorder required by the operating rules of title 14, chapter I must be
approved and must be installed so that it will record the following:
(1) Voice communications transmitted from or received in the aircraft by radio.
(2) Voice communications of flightcrew members on the flightdeck.
(3) Voice communications of flightcrew members on the flightdeck, using the aircraft's
interphone system.
(4) Voice or audio signals identifying navigation or approach aids introduced into a headset or
speaker.
(5) Voice communications of flightcrew members using the passenger loudspeaker system, if
there is such a system and if the fourth channel is available in accordance with the requirements
of paragraph (c)(4)(ii) of this section.
(6) If datalink communication equipment is installed, all datalink communications, using an
approved data message set. Datalink messages must be recorded as the output signal from the
communications unit that translates the signal into usable data.
(b) The recording requirements of paragraph (a)(2) of this section must be met by installing a
cockpit-mounted area microphone, located in the best position for recording voice
communications originating at the first and second pilot stations and voice communications of
other crewmembers on the flightdeck when directed to those stations. The microphone must be
so located and, if necessary, the preamplifiers and filters of the recorder must be so adjusted or
supplemented, so that the intelligibility of the recorded communications is as high as practicable
when recorded under flight cockpit noise conditions and played back. Repeated aural or visual
playback of the record may be used in evaluating intelligibility.
(c) Each cockpit voice recorder must be installed so that the part of the communication or audio
signals specified in paragraph (a) of this section obtained from each of the following sources is
recorded on a separate channel:
(1) For the first channel, from each boom, mask, or handheld microphone, headset, or speaker
used at the first pilot station.
(2) For the second channel from each boom, mask, or handheld microphone, headset, or speaker
used at the second pilot station.
(3) For the third channel—from the cockpit-mounted area microphone.
(4) For the fourth channel from:
(i) Each boom, mask, or handheld microphone, headset, or speaker used at the station for the
third and fourth crewmembers.
A-1
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Begin with the aircraft and the agreed basis.
Connect the operating concept, aircraft-level failure effects, system architecture and assurance planning. Keep FAA powered-lift criteria and EASA SC-VTOL provisions distinct when developing the safety and certification approach.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.