Appendix A gives an acceptable means for certain powered-lift under §21.17(b). These criteria are not universally applicable CFR requirements; establish the basis for the particular aircraft.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
07/18/2025 AC 21.17-4
Appendix A
PL.2500 Aircraft level systems requirements.
This section applies generally to installed equipment and systems unless a section of these
airworthiness criteria imposes requirements for a specific piece of equipment, system, or
systems.
(a) The equipment and systems required for an aircraft to operate safely in the kinds of
operations for which certification is requested must be designed and installed to—
(1) Meet the level of safety applicable to the certification and performance level of the aircraft;
and
(2) Perform their intended function throughout the operating and environmental limits for which
the aircraft is certificated.
(b) The systems and equipment not covered by paragraph (a) of this section, considered
separately and in relation to other systems, must be designed and installed so their operation does
not have an adverse effect on the aircraft or its occupants.
PL.2505 Function and installation.
When installed, each item of equipment must function as intended.
PL.2510 Equipment, systems, and installations.
This section applies to failures or abnormal operation of any equipment or system installed on
the aircraft unless superseded by requirements contained in another section of these
airworthiness criteria for which failures or abnormal operations are specified. The applicant must
design and install each system and equipment, such that there is a logical and acceptable inverse
relationship between the average probability and the severity of failure conditions to the extent
that:
(a) Each catastrophic failure condition is extremely improbable;
(b) Each hazardous failure condition is extremely remote; and
(c) Each major failure condition is remote.
PL.2515 Electrical- and electronic-system lightning protection.
(a) Each electrical or electronic system that performs a function, the failure of which would
prevent the continued safe flight and landing of the aircraft, must be designed and installed such
that—
(1) The function at the aircraft level is not adversely affected during and after the time the
aircraft is exposed to lightning; and
(2) The system recovers normal operation of that function in a timely manner after the aircraft is
exposed to lightning unless the system’s recovery conflicts with other operational or functional
requirements of the system.
(b) For an aircraft approved for operation under instrument flight rules (IFR), each electrical and
electronic system that performs a function, the failure of which would reduce the capability of
the aircraft or the ability of the flightcrew to respond to an adverse operating condition, must be
designed and installed such that the system recovers normal operation of that function in a timely
manner after the aircraft is exposed to lightning.
A-22
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Begin with the aircraft and the agreed basis.
Connect the operating concept, aircraft-level failure effects, system architecture and assurance planning. Keep FAA powered-lift criteria and EASA SC-VTOL provisions distinct when developing the safety and certification approach.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.