FAA / Advisory circular

AC 21.17-4

Type Certification—Powered-lift

Follow the FAA powered-lift certification approach and navigate the airworthiness criteria in Appendix A.

Start with the scope.

Appendix A gives an acceptable means for certain powered-lift under §21.17(b). These criteria are not universally applicable CFR requirements; establish the basis for the particular aircraft.

The source, within reach.

Search within this AC, jump to a source page, or download the complete saved publication.

Download saved FAA PDF ↓

Read the source

The document, within reach.

FAA source document

Printed page A-47

PDF page 56 of 64

Enlarge original ↗

Original source view; text reflow has not yet been reviewed

Original FAA AC 21.17-4, PDF page 56
AC 21.17-4 · A-47Open saved PDF here ↗
Extracted text for finding words

This extraction supports search. Read the original page for complete notation and layout.

07/18/2025                                              AC 21.17-4
                                                                        Appendix A

section or in a separate component test for a period of one hour to a load equivalent to twice the
maximum centrifugal load to which the propeller would be subjected during operation at the
maximum rated rotational speed.
(c) Components used with or attached to the propeller (for example, spinners, de-icing
equipment, and blade erosion shields) must be subjected to a load equivalent to 159 percent of
the maximum centrifugal load to which the component would be subjected during operation at
the maximum rated rotational speed. This must be performed by either:
(1) Testing at the required load for a period of 30 minutes; or
(2) Analysis based on test.
PL.3536 Bird impact.
The applicant must demonstrate, by tests or analysis based on tests or experience on similar
designs, that the propeller can withstand the impact of a 4-pound bird at the critical location(s)
and critical flight condition(s) of the intended aircraft application without causing a major or
hazardous propeller effect.
PL.3537 Fatigue limits and evaluation.
(a) Fatigue limits must be established by tests, or analysis based on tests, for propeller:
(1) Hubs.
(2) Blades.
(3) Blade retention components.
(4) Components which are affected by fatigue loads and which are shown under PL.3515 to have
a fatigue failure mode leading to hazardous propeller effects.
(b) The fatigue limits must take into account:
(1) All known and reasonably foreseeable vibration and cyclic load patterns that are expected in
service; and
(2) Expected service deterioration, variations in material properties, manufacturing variations,
and environmental effects.
(c) A fatigue evaluation of the propeller must be conducted to show that hazardous propeller
effects due to fatigue will be avoided throughout the intended operational life of the propeller on
the intended aircraft by complying with PL.2400(c) of these airworthiness criteria.
(d) Engine-driven lift devices must also comply with fatigue and damage tolerance evaluation
defined in subpart C.
(e) Elastomeric components of engine-driven lift devices must show required dynamic
performance for fatigue and damage tolerance defined in subpart C.
PL.3538 Lightning strike.
The applicant must demonstrate, by tests, analysis based on tests, or experience on similar
designs, that the propeller can withstand a lightning strike without causing a major or hazardous
propeller effect. The limit to which the propeller has been qualified must be documented in the
appropriate manuals.

                                       A-47

Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.

Aerospace Consulting / Engineering perspective

Begin with the aircraft and the agreed basis.

Connect the operating concept, aircraft-level failure effects, system architecture and assurance planning. Keep FAA powered-lift criteria and EASA SC-VTOL provisions distinct when developing the safety and certification approach.

Explore our eVTOL safety and certification approach →
Source edition and reading coverage

64 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.

Source SHA-256: e1a60e5f5ed4f34764beb0866a0a1b65471832a1cf169ef670a6dd6bf434297e

This is a dated source copy. Automatic source acquisition is not yet scheduled.

Original FAA PDF ↗

Working through a certification question?

Bring the aircraft, the basis and the issue your team needs to resolve.

Discuss your programme →