Appendix A gives an acceptable means for certain powered-lift under §21.17(b). These criteria are not universally applicable CFR requirements; establish the basis for the particular aircraft.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
07/18/2025 AC 21.17-4
Appendix A
SUBPART I—ELECTRIC ENGINE
PL.3305 Instruction manual for installing and operating the engine.
Each applicant must prepare and make available to the Administrator prior to the issuance of the
type certificate, and to the owner at the time of delivery of the engine, approved instructions for
installing and operating the engine. The instructions must include at least the following:
(a) Installation instructions.
(1) The location of engine mounting attachments, the method of attaching the engine to the
aircraft, and the maximum allowable load for the mounting attachments and related structure.
(2) The location and description of engine connections to be attached to accessories, pipes, wires,
cables, ducts, and cowling.
(3) An outline drawing of the engine including overall dimensions.
(4) A definition of the physical and functional interfaces with the aircraft and aircraft equipment,
including the propeller when applicable.
(5) Where an engine system relies on components that are not part of the engine type design, the
interface conditions and reliability requirements for those components upon which engine
approval is based must be specified in the engine installation instructions directly or by reference
to appropriate documentation.
(6) A list of the instruments necessary for control of the engine, including the overall limits of
accuracy and transient response required of such instruments for control of the operation of the
engine, must also be stated so that the suitability of the instruments as installed may be assessed.
(b) Operation instructions.
(1) The operating limitations established by the Administrator.
(2) The power or thrust ratings and procedures for correcting for nonstandard atmosphere.
(3) The recommended procedures, under normal and extreme ambient conditions for:
(i) Starting;
(ii) Operating on the ground; and
(iii) Operating during flight.
(4) For engines having one or more engine inoperative ratings or other contingency ratings,
applicants must provide data on engine performance characteristics and variability to enable the
aircraft manufacturer to establish aircraft power assurance procedures.
(5) A description of the primary and all alternate modes, and any back-up system, together with
any associated limitations, of the engine control system and its interface with the aircraft
systems, including the propeller when applicable.
(c) Safety analysis assumptions. The assumptions of the safety analysis as described in
PL.3375(d) with respect to the reliability of safety devices, instrumentation, early warning
devices, maintenance checks, and similar equipment or procedures that are outside the control of
the engine manufacturer.
A-28
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Begin with the aircraft and the agreed basis.
Connect the operating concept, aircraft-level failure effects, system architecture and assurance planning. Keep FAA powered-lift criteria and EASA SC-VTOL provisions distinct when developing the safety and certification approach.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.