Appendix A gives an acceptable means for certain powered-lift under §21.17(b). These criteria are not universally applicable CFR requirements; establish the basis for the particular aircraft.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
07/18/2025 AC 21.17-4
Appendix A
(3) Be shown to maintain its intended floating attitude in the sea conditions selected by the
applicant.
(c) If certification with ditching provisions is requested, the aircraft must:
(1) Be equipped with an approved emergency flotation system that does not rely on manual
activation;
(2) Withstand the applicable water loads; and
(3) Be shown to have a safe water entry and to maintain its intended floating attitude in the sea
conditions selected by the applicant.
PL.2311 Bird Strike.
The aircraft must be capable of continued safe flight and landing after impact with a 2.2-lb (1.0
kg) bird.
Occupant System Design Protection
PL.2315 Means of egress and emergency exits.
With the cabin configured for takeoff or landing, the aircraft is designed to:
(a) Facilitate rapid and safe evacuation of the aircraft in conditions likely to occur following an
emergency landing, including on water if an emergency flotation system is included.
(b) Have means of egress (openings, exits, or emergency exits), that can be readily located and
opened from the inside and outside. The means of opening must be simple and obvious and
marked inside and outside the aircraft. If an emergency flotation system is included, the means of
egress must be above the water in the intended floating attitude.
(c) Have easy access to emergency exits when present.
PL.2320 Occupant physical environment.
(a) The applicant must design the aircraft to—
(1) Allow clear communication between the flightcrew and passengers;
(2) Protect the pilot and flight controls from propellers; and
(3) Protect the occupants from serious injury due to damage to windshields, windows, and
canopies.
(b) The aircraft must provide each occupant with air at a breathable pressure, free of hazardous
concentrations of gases, vapors, and smoke during normal operations and likely failures.
(c) If a pressurization system is installed in the aircraft, it must be designed to protect against—
(1) Decompression to an unsafe level; and
(2) Excessive differential pressure.
(d) If an oxygen system is installed in the aircraft, it must—
(1) Effectively provide oxygen to each user to prevent the effects of hypoxia; and
(2) Be free from hazards in itself, in its method of operation, and its effect upon other
components.
A-18
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Begin with the aircraft and the agreed basis.
Connect the operating concept, aircraft-level failure effects, system architecture and assurance planning. Keep FAA powered-lift criteria and EASA SC-VTOL provisions distinct when developing the safety and certification approach.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.