Appendix A gives an acceptable means for certain powered-lift under §21.17(b). These criteria are not universally applicable CFR requirements; establish the basis for the particular aircraft.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
07/18/2025 AC 21.17-4
Appendix A
PL.2125 Climb information.
(a) The applicant must determine climb performance at each weight, altitude, and ambient
temperature within the operating limitations using the procedures published in the flight manual.
(b) The applicant must determine climb performance accounting for any critical change of thrust.
(c) The applicant must determine the performance accordingly for the appropriate sources of lift
applicable to the conditions defined in PL.2105(f).
PL.2130 Landing.
The applicant must determine the following, for critical combinations of weight, altitude, and
temperatures within the operational limits:
(a) The approach and landing speeds and procedures, which allow a pilot of average skill to land
within the published landing distance consistently and without causing damage or injury, and
which allow for a safe transition to the balked landing conditions of these airworthiness criteria
accounting for:
(1) All sources of lift for each approach and landing flight path for which certification is sought,
(2) Any minimum or maximum speed safety margins, and
(3) Minimum control speeds.
(b) For aircraft approved for essential performance, the applicant must determine the landing
performance from a height of 50 feet above the landing surface. Additionally, the aircraft must
be capable of performing a safe landing at any point along the approach flight path following a
critical change of thrust.
(c) For aircraft approved for increased performance, the applicant must determine the landing
performance from a height of 50 feet above the landing surface so that, following a critical
change of thrust that occurs—
(1) Prior to the landing decision point, which may be a speed, an altitude, or other critical flight
parameters selected by the applicant, the aircraft can:
(i) Land and stop safely on the landing surface; or
(ii) Transition to the balked landing condition and performance established in PL.2120.
(2) After passing the landing decision point, the aircraft can land and stop safely on the landing
surface.
Flight Characteristics
PL.2135 Controllability and maneuverability.
(a) The aircraft must be controllable and maneuverable, without requiring exceptional piloting
skill, alertness, or strength, within the approved flight envelope—
(1) At all loading conditions for which certification is requested;
(2) During all phases of flight;
(3) In degraded flight control system operating modes and likely flight control or propulsion
system failures;
A-8
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Begin with the aircraft and the agreed basis.
Connect the operating concept, aircraft-level failure effects, system architecture and assurance planning. Keep FAA powered-lift criteria and EASA SC-VTOL provisions distinct when developing the safety and certification approach.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.