FAA / Advisory circular

AC 21.17-4

Type Certification—Powered-lift

Follow the FAA powered-lift certification approach and navigate the airworthiness criteria in Appendix A.

Start with the scope.

Appendix A gives an acceptable means for certain powered-lift under §21.17(b). These criteria are not universally applicable CFR requirements; establish the basis for the particular aircraft.

The source, within reach.

Search within this AC, jump to a source page, or download the complete saved publication.

Download saved FAA PDF ↓

Read the source

The document, within reach.

FAA source document

Printed page A-6

PDF page 15 of 64

Enlarge original ↗

Original source view; text reflow has not yet been reviewed

Original FAA AC 21.17-4, PDF page 15
AC 21.17-4 · A-6Open saved PDF here ↗
Extracted text for finding words

This extraction supports search. Read the original page for complete notation and layout.

07/18/2025                                               AC 21.17-4
                                                                        Appendix A

(b) Unless otherwise prescribed, the applicant must develop the performance data required by
this subpart for the conditions within the approved flight envelope.
(c) The procedures used for determining takeoff and landing performance must consider all the
applicable configurations and be executable consistently by pilots of average skill in the
atmospheric conditions expected to be encountered in service.
(d) Performance data determined in accordance with this section must account for losses due to
atmospheric conditions, cooling needs, installation, downwash considerations, and other
demands on power sources.
(e) The hovering ceiling, in and out of ground effect, if applicable, must be determined within
the approved flight envelope.
(f) Following a condition when the aircraft can no longer provide the commanded power or
thrust required for continued safe flight and landing, the aircraft must be capable of a controlled
emergency landing by gliding, autorotation, or an equivalent means to mitigate the risk of loss of
power or thrust. The aircraft design must allow for the pilot to choose the direction and area of
touchdown while reasonably protecting the occupants from injury. Upon landing, some damage
to the aircraft may be acceptable.
PL.2110 Flight profiles
The applicant must determine the flight profiles for which certification is being sought. Flight
profiles refer to the grouping of flight phases, associated maneuvers, procedures, safe speeds
inclusive of minimum speeds which may be stall speeds, operational conditions, and other
critical flight references for the most adverse conditions consistent with the approved flight
envelope.
PL.2115 Takeoff performance.
(a) The applicant must determine takeoff performance for all configurations for which approval
is sought accounting for:
(1) The approved flight envelope, and
(2) Climb requirements.
(b) For aircraft approved for essential performance, the applicant must determine the takeoff
performance to 50 feet above the takeoff surface such that a rejected takeoff resulting in safe stop
or landing can be made at any point along the takeoff flight path following a critical change of
thrust.
(c) For aircraft approved for increased performance, the applicant must determine the takeoff
performance so that—
(1) Following a critical change of thrust prior to reaching the takeoff decision point, a rejected
takeoff resulting in a safe stop or landing can be made. The takeoff decision point may be a
speed, an altitude, or other critical flight parameters selected by the applicant; and
(2) Following a critical change of thrust after passing the takeoff decision point, the aircraft
can—
(i) Continue the takeoff and climb to 50 feet above the takeoff surface; and


                                        A-6

Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.

Aerospace Consulting / Engineering perspective

Begin with the aircraft and the agreed basis.

Connect the operating concept, aircraft-level failure effects, system architecture and assurance planning. Keep FAA powered-lift criteria and EASA SC-VTOL provisions distinct when developing the safety and certification approach.

Explore our eVTOL safety and certification approach →
Source edition and reading coverage

64 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.

Source SHA-256: e1a60e5f5ed4f34764beb0866a0a1b65471832a1cf169ef670a6dd6bf434297e

This is a dated source copy. Automatic source acquisition is not yet scheduled.

Original FAA PDF ↗

Working through a certification question?

Bring the aircraft, the basis and the issue your team needs to resolve.

Discuss your programme →