FAA / Advisory circular

AC 21.17-4

Type Certification—Powered-lift

Follow the FAA powered-lift certification approach and navigate the airworthiness criteria in Appendix A.

Start with the scope.

Appendix A gives an acceptable means for certain powered-lift under §21.17(b). These criteria are not universally applicable CFR requirements; establish the basis for the particular aircraft.

The source, within reach.

Search within this AC, jump to a source page, or download the complete saved publication.

Download saved FAA PDF ↓

Read the source

The document, within reach.

FAA source document

Printed page A-4

PDF page 13 of 64

Enlarge original ↗

Original source view; text reflow has not yet been reviewed

Original FAA AC 21.17-4, PDF page 13
AC 21.17-4 · A-4Open saved PDF here ↗
Extracted text for finding words

This extraction supports search. Read the original page for complete notation and layout.

07/18/2025                                               AC 21.17-4
                                                                        Appendix A

(c) A correlation must be established between the flight recorder readings of airspeed, altitude,
and heading and the corresponding readings (taking into account correction factors) of the first
pilot's instruments. The correlation must cover the airspeed range over which the aircraft is to be
operated, the range of altitude to which the aircraft is limited, and 360 degrees of heading.
Correlation may be established on the ground as appropriate.
(d) Each recorder container must—
(1) Be either bright orange or bright yellow;
(2) Have reflective tape affixed to its external surface to facilitate its location under water; and
(3) Have an underwater locating device, when required by the operating rules of this chapter, on
or adjacent to the container, which is secured in such a manner that they are not likely to be
separated during crash impact.
(e) Any novel or unique design or operational characteristics of the aircraft shall be evaluated to
determine if any dedicated parameters must be recorded on flight recorders in addition to or in
place of existing requirements.
PL.1529 Instructions for continued airworthiness.
The applicant must prepare Instructions for Continued Airworthiness (ICA), in accordance with
subparts K, L, and M, that are acceptable to the Administrator. ICA for the aircraft, engines, and
propellers may be shown in a single aircraft ICA manual if the engine and propeller approvals
are sought through the aircraft certification program. Alternatively, the applicant may provide
individual ICA for the aircraft, engines, and propellers. The instructions may be incomplete at
the time of type certification if a program exists to ensure their completion prior to delivery of
the first aircraft, or issuance of a standard certificate of airworthiness, whichever occurs later.
SUBPART A—GENERAL
PL.2000 Applicability and definitions.
(a) These airworthiness criteria prescribe airworthiness standards for the issuance of a type
certificate, and changes to that type certificate, for powered-lift with maximum weights of
12,500 pounds or less and a maximum passenger seating configuration of six or less. The aircraft
must be certificated in accordance with either the “essential performance” or “increased
performance” requirements of these airworthiness criteria. The aircraft may also be type
certificated as both “essential performance” and “increased performance” with appropriate and
different operating limitations for each approval.
(b) For purposes of these airworthiness criteria, the following definitions apply:
(1) Essential performance means, in the event of a critical change of thrust, the aircraft has no
guaranteed climb capability but is capable of controlled flight and an unscheduled landing is
assumed.
(2) Increased performance means, in the event of a critical change of thrust, the aircraft is
capable of climbing to a safe altitude, on a flightpath clear of obstacles, and maintaining level
flight to a planned destination, a diversion location, or the point of departure.
(3) Phases of flight means ground operations, takeoff, climb, cruise, descent, approach, hover,
and landing.

                                        A-4

Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.

Aerospace Consulting / Engineering perspective

Begin with the aircraft and the agreed basis.

Connect the operating concept, aircraft-level failure effects, system architecture and assurance planning. Keep FAA powered-lift criteria and EASA SC-VTOL provisions distinct when developing the safety and certification approach.

Explore our eVTOL safety and certification approach →
Source edition and reading coverage

64 original pages. 0 pages have reviewed text reflows. Original-first pages retain the source layout, with extracted text available for finding words.

Source SHA-256: e1a60e5f5ed4f34764beb0866a0a1b65471832a1cf169ef670a6dd6bf434297e

This is a dated source copy. Automatic source acquisition is not yet scheduled.

Original FAA PDF ↗

Working through a certification question?

Bring the aircraft, the basis and the issue your team needs to resolve.

Discuss your programme →