Appendix A gives an acceptable means for certain powered-lift under §21.17(b). These criteria are not universally applicable CFR requirements; establish the basis for the particular aircraft.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
07/18/2025 AC 21.17-4
Appendix A
program that includes the frequency and extent of the inspections necessary to provide for the
continued airworthiness of the aircraft.
(2) Troubleshooting information describing probable malfunctions, how to recognize those
malfunctions, and the remedial action for those malfunctions.
(3) Information describing the order and method of removing and replacing products and parts
with any necessary precautions to be taken.
(4) Other general procedural instructions including procedures for system testing during ground
running, symmetry checks, weighing and determining the center of gravity, lifting and shoring,
and storage limitations.
(c) Diagrams of structural access plates and information needed to gain access for inspections
when access plates are not provided.
(d) Details for the application of special inspection techniques including radiographic and
ultrasonic testing where such processes are specified by the applicant.
(e) Information needed to apply protective treatments to the structure after inspection.
(f) All data relative to structural fasteners such as identification, discard recommendations, and
torque values.
(g) A list of special tools needed.
PL.4104 Airworthiness limitations section.
The Instructions for Continued Airworthiness must contain a section titled Airworthiness
Limitations that is segregated and clearly distinguishable from the rest of the document. This
section must set forth each mandatory maintenance action required for type certification. If the
Instructions for Continued Airworthiness consist of multiple documents, the section required by
this paragraph must be included in the principal manual. This section must contain a legible
statement in a prominent location that reads “The Airworthiness Limitations section is FAA
approved and specifies maintenance required under §§ 43.16 and 91.403 of the Federal Aviation
Regulations unless an alternative program has been FAA approved.”
SUBPART L—INSTRUCTIONS FOR CONTINUED AIRWORTHINESS (ELECTRIC
ENGINE)
PL.4301 General.
(a) This subpart specifies requirements for the preparation of ICA for the engines as required by
PL.1529.
(b) The ICA for the engine must include the ICA for all engine parts.
(c) The applicant must submit to the FAA a program to show how the applicant’s changes to the
ICA will be distributed, if applicable.
PL.4302 Format.
(a) The Instructions for Continued Airworthiness must be in the form of a manual or manuals as
appropriate for the quantity of data to be provided.
(b) The format of the manual or manuals must provide for a practical arrangement.
A-51
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Begin with the aircraft and the agreed basis.
Connect the operating concept, aircraft-level failure effects, system architecture and assurance planning. Keep FAA powered-lift criteria and EASA SC-VTOL provisions distinct when developing the safety and certification approach.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.