Appendix A gives an acceptable means for certain powered-lift under §21.17(b). These criteria are not universally applicable CFR requirements; establish the basis for the particular aircraft.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
07/18/2025 AC 21.17-4
Appendix A
PL.2703 IFR flight envelope.
The applicant must determine an approved IFR flight envelope specifically for operations for
flight into IFR conditions. If the approved IFR flight envelope differs from the approved flight
envelope, then the applicant must use instrument flight speeds to comply with this subpart.
PL.2705 Definitions.
(a) VYI means instrument climb speed, utilized instead of VY for compliance with the climb
requirements for instrument flight, if different than climb speed as defined in PL.2120.
(b) VMINI means instrument flight minimum speed, utilized in complying with minimum limit
speed requirements for instrument flight, if different than the flight profiles established under
PL.2110.
(c) A practical flight envelope means a flight envelope where, in the event of flight control,
propulsive, or stability augmentation malfunctions, compliance with controllability and
maneuverability requirements must be demonstrated.
PL.2707 Trim.
The aircraft must meet the requirements in PL.2140 for all approved IFR airspeeds, power
settings, and configurations appropriate to the type.
PL.2709 Stability and handling qualities.
The aircraft must meet the requirements in PL.2145 for the approved IFR airspeeds, power
settings, and configurations appropriate to the type.
PL.2711 Stability augmentation.
For any failure or combination of failures not shown to be extremely improbable, the aircraft
must be capable of continued safe flight and landing. In addition—
(a) The aircraft must remain safely controllable when the failure or malfunction occurs within the
approved IFR flight envelope; and
(b) The overall flight characteristics must allow for prolonged flight without undue pilot effort.
Additional unrelated probable failures affecting the control system must be considered. In
addition—
(1) The controllability, maneuverability, and stability requirements in subpart B must be met
throughout a practical flight envelope; and
(2) The flight control, trim, and flying qualities must not be reduced below that needed for
continued safe flight and l anding.
PL.2713 Equipment, systems, and installation.
The basic equipment and installation must comply with PL.2500, PL.2505, PL.2510, PL.2525
and PL.2615, with the following additions:
(a) Instrument systems and other systems essential for IFR flight that could be adversely affected
by icing must be adequately protected when exposed to atmospheric icing conditions.
(b) For each instrument essential for instrument flight—
A-26
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Begin with the aircraft and the agreed basis.
Connect the operating concept, aircraft-level failure effects, system architecture and assurance planning. Keep FAA powered-lift criteria and EASA SC-VTOL provisions distinct when developing the safety and certification approach.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.