This AC recognises DO-254/ED-80 and adds objectives for distinct hardware categories. Its stated applicability covers hardware contributing to DAL A, B and C functions; the relevant objective restrictions still apply.
The source, within reach.
Search within this AC, jump to a source page, or download the complete saved publication.
This extraction supports search. Read the original page for complete notation and layout.
U.S. D epartment Advisory of Tra nsportation
Federal Aviation Administration Circular
Subject: Development Assurance for Airborne Date: 10/7/22 AC No: 20-152A
Electronic Hardware Initiated By: AIR-622
1 PURPOSE
This advisory circular (AC) describes an acceptable means, but not the only means, for
showing compliance with the applicable airworthiness regulations for the electronic
hardware aspects of airborne systems and equipment for type certification or Technical
Standard Order (TSO) authorization. The contents of this document do not have the
force and effect of law and are not meant to bind the public in any way. This document
is intended only to provide clarity to the public regarding existing requirements under
the law or agency policies. However, if you use the means described in the AC, you
should follow it in all applicable respects unless alternate means or deviations are
proposed and accepted by the FAA.
This AC recognizes EUROCAE ED-80, Design Assurance Guidance for Airborne
Electronic Hardware, dated April 2000, and RTCA DO-254, Design Assurance
Guidance for Airborne Electronic Hardware, dated April 19, 2000.
This AC describes when to apply EUROCAE ED-80/RTCA DO-254, and it
supplements EUROCAE ED-80/RTCA DO-254 with additional guidance and
clarification for the development of custom devices, including the use of commercial
off-the-shelf (COTS) intellectual property (IP), for the use of COTS devices, and for the
development of circuit board assemblies (CBA).
The additional guidance and clarification are provided in the form of objectives. The
applicant is expected to describe the process and activities to satisfy the objectives of
this AC.
Note: EUROCAE ED-80 is hereafter referred to as “ED”; RTCA DO-254 is hereafter
referred to as “DO.” Where the notation “ED-80/DO-254” appears in this document,
the referenced documents are recognized as being equivalent.
This AC does not address the Single Event Effects (SEE) aspects or the assessment of
the hardware susceptibility to SEE. However, the Plan for Hardware Aspects of
Certification may still be used to document the certification considerations for Single
Event Effects.
Saved from the FAA on November 17, 2026. All original pages are retained. Engineering explanations are presented separately below.
Aerospace Consulting / Engineering perspective
Define the hardware assurance approach by function and device.
Use the PHAC to identify intended functions, assurance levels, custom and COTS boundaries, and the evidence needed for each applicable objective. Keep supplier information, integration verification and system-level assumptions connected.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.