The following values and limitations must be established to show compliance with the structural requirements of this subpart:
(a) The design maximum weight.
(b) The main rotor r.p.m. ranges power on and power off.
(c) The maximum forward speeds for each main rotor r.p.m. within the ranges determined under paragraph (b) of this section.
(d) The maximum rearward and sideward flight speeds.
(e) The center of gravity limits corresponding to the limitations determined under paragraphs (b), (c), and (d) of this section.
(f) The rotational speed ratios between each powerplant and each connected rotating component.
(g) The positive and negative limit maneuvering load factors.
About this text
Source: OFR/GPO eCFR. The wording is reproduced from the dated source, with formatting adapted for reading. The eCFR is an editorial compilation and is not the official legal edition of the CFR.
A focused review, an agreed assessment package or ongoing support alongside your team. We can agree the relevant inputs and scope in the initial conversation.
This opens your email application.
Start a conversation
Tell us about your programme, the system you are developing and the support you need.
We can agree a focused use-case review, a defined evidence package or ongoing programme support.
This opens your email application.
Specialist aerospace expertise
Aerospace Consulting is led by Hussein Khimji, an FAA Designated Engineering Representative in systems and equipment, with a focus on system safety, flight controls and avionics.
We work with aircraft developers and systems suppliers to connect technical decisions, safety assessments and certification evidence.
This is the proposed introduction. The full About page will add your approved biography and associate expertise.
Systems engineering & development assurance
Tell us about the aircraft or system, its intended function, stage of development and the support you need.